Launch PC Probe II by clicking Start > All Programs > ASUS > PC Probe II > PC Install PC Probe II from the motherboard support DVD. With this utility, you are assured that your computer is always at a healthy operating condition.ġ. Because PC Probe II is software-based, you can start monitoring your computer the moment you turn it on. PC Probe II senses fan rotations, CPU temperature, and system voltages, among others. PC Probe II is a utility that monitors the computer's vital components, and detects and alerts you of any problem with these components. View the online help or readme file that came with the software application for more information. Refer to section 3.7 Power menu in Chapter 3 for details.Most of the applications in the support DVD have wizards that will conveniently guide you through the installation. Pressing the power switch for more than four seconds lets the system enter the soft-off mode regardless of the BIOS setting. While the system is ON, pressing the power switch for less than four seconds puts the system on sleep mode or soft-off mode, depending on the BIOS setting. At power on, hold down the key to enter the BIOS Setup. One continuous beep followed by two short beeps then a pause (repeated) One continuous beep followed by three short beeps One continuous beep followed by four short beepsĭescription VGA detected Quick boot set to disabled No keyboard detectedħ. Check the jumper settings and connections or call your retailer for assistance. If you do not see anything within 30 seconds from the time you turned on the power, the system may have failed a power-on test. While the tests are running, the BIOS beeps (see the BIOS beep codes table below) or additional messages appear on the screen. The system then runs the power-on self tests or POST. If your monitor complies with the "green" standards or if it has a "power standby" feature, the monitor LED may light up or change from orange to green after the system LED turns on. For systems with ATX power supplies, the system LED lights up when you press the ATX power button. After applying power, the system power LED on the system front panel case lights up. External SCSI devices (starting with the last device on the chain)Ħ. Turn on the devices in the following order:ī. Connect the power cord to a power outlet that is equipped with a surge protector.ĥ. Connect the power cord to the power connector at the back of the system chassis.Ĥ. After making all the connections, replace the system case cover.ģ.
0 kommentar(er)
